Backwater valve in a Quebec co-ownership: who pays?
Every year, Quebec municipalities require the installation of a backwater valve on sewer lines. In a divided co-ownership, the same question immediately comes up: who pays—the syndicate or each co-owner? The answer depends on the declaration of co-ownership, the location of the device and the applicable legal framework.
In this article, you will learn how to quickly determine the proper allocation of costs, what steps the board of directors should take and what to document to avoid disputes at the AGM. References to the Civil Code of Québec, the Construction Code Regulation and best practices will guide you.
Article updated as of September 15, 2026.
Why municipalities require a backwater valve
A backwater valve prevents sewage from backing up into the building during storms or when the municipal system is overloaded. It is an essential protective device for limiting damage in the common portions and units.
In Quebec, technical requirements stem in particular from the Construction Code and RBQ guidelines concerning backflow-prevention devices. Several municipalities require a backwater valve during major work, conversions or following repeated flooding. The syndicate must then comply within a reasonable timeframe by hiring a qualified contractor.
- RBQ reference on sewer backflow-prevention devices: https://www.rbq.gouv.qc.ca/ (see the plumbing and backflow-prevention section)
For reference, the syndicate’s purpose is to preserve the building and administer the common portions (see section 1039 of the C.C.Q., LégisQuébec). These duties include taking reasonable preventive measures against backflow.
Common portions vs. private portions: where is the backwater valve located?
The key to determining who pays is first to locate the backwater valve on the drainage system.
- If the backwater valve is installed on the main line (sewer drain) before the line exits the building, it protects the entire building. It is therefore generally considered a common portion.
- If it is installed on a unit branch, upstream from the plumbing fixtures of a single fraction, it benefits almost exclusively that fraction. Unless the declaration of co-ownership provides otherwise, it is therefore treated as a private portion.
- In some buildings, backwater valves are located in the garage or basement on a common stack serving several floors; these devices remain common portions.
The declaration of co-ownership and architectural plans specify the boundary between common portions and private portions for plumbing. Many declarations of co-ownership identify vertical stacks, pipes embedded in slabs and the main line as common portions, while branches within the unit are private portions. Also check the building bylaws for any maintenance or access rules.
- Co-ownership best practices – RGCQ: https://rgcq.org/
- Definition and administration of common portions – C.C.Q. (LégisQuébec): https://www.legisquebec.gouv.qc.ca/
Who pays: general rule and exceptions
General rule:
- Common portion: costs are assumed by the syndicate through common expenses, according to the relative value of each fraction (see contribution to common expenses, section 1063 of the C.C.Q., LégisQuébec).
- Private portion: the co-owner of the fraction assumes the cost of installation, maintenance and replacement, unless the declaration of co-ownership assigns certain components differently.
Common exceptions and nuances:
- Work required “for the building” by the municipality: even if work is carried out in several units, when the measure is intended to protect the building as a whole and affects sections considered common under the declaration of co-ownership, the expense is generally common.
- Specific provision in the declaration of co-ownership: some declarations classify pipes up to the first shut-off valve as common portions. Review the technical clauses before making a decision.
- Fault or negligence: if a co-owner modified their plumbing contrary to the rules and caused damage, the syndicate may claim costs from that co-owner, subject to proof and the mechanisms provided for in the declaration of co-ownership and the C.C.Q.
- Insurance: the syndicate’s insurer may cover some of the damage related to a backup, subject to the deductible and exclusions. This does not necessarily change the allocation of compliance costs.
Refer to the syndicate’s obligation to preserve the building (section 1039 of the C.C.Q.) and the contribution rules (section 1063 of the C.C.Q.). If the work constitutes a major repair or replacement of a common portion, funding may come from the contingency fund (see section 1071 of the C.C.Q.).
Typical cases to decide
- Backwater valve on the main line, in the mechanical room: common expense, decision by the board of directors, information provided at the AGM.
- Unit backwater valves required for all ground-floor fractions: often a series of work, but private if installed on each unit branch. The syndicate may coordinate the call for tenders to reduce costs, while billing remains individual.
- Grouped replacement of existing backwater valves on a common stack: common expense, which may be scheduled in the maintenance logbook/EUC and budgeted through the contingency fund if the useful life has been reached.
What to document when deciding who pays
- The declaration of co-ownership and its attached technical plans.
- The precise location of the backwater valve on a plumbing diagram.
- The municipal notice or request received.
- The recommendations of the RBQ-licensed plumbing contractor.
- The board’s resolutions and the minutes confirming the cost-allocation decision.
- Relevant legislation – C.C.Q. on expenses and administration: https://www.legisquebec.gouv.qc.ca/
- Technical references – RBQ, plumbing and backflow prevention: https://www.rbq.gouv.qc.ca/
Compliance process: steps for the board
- Confirm the scope of the municipal requirement. Determine whether the request applies to the entire building or certain units.
- Retain an RBQ-licensed plumbing contractor with the relevant licences for an assessment. Require a report locating the proposed devices and explaining the rationale for their selection.
- Compare at least two quotes. For a common device, favour a contract in the syndicate’s name. For a series of private installations, establish a common coordination framework and clear billing agreements.
- Make a decision at the board level and, if necessary, call an AGM if a special assessment is required. Record the decision and cost allocation in the minutes.
- Update the maintenance logbook/EUC with the inspection frequency, useful life and access points.
- Inform co-owners of the access required to units, work dates and instructions (e.g., clear the access hatch). Specify the consequences of refusing access in accordance with the building bylaws.
- Notify the syndicate’s insurer of the preventive measure installed and retain the certificates of compliance provided by the contractor.
For an overview of the roles and services that can support your board, visit our service pages: Operations management, Administrative management and Financial management.
Cost allocation and budgeting: expenses, funds and assessments
- Regular common expenses: if the common backwater valve is considered maintenance or a minor improvement, the expense may be included in the annual common-expense budget.
- Contingency fund: for a major replacement or installation involving a common portion, the expense may come from the contingency fund if it is a major repair or replacement within the meaning of the C.C.Q. and the EUC planning.
- Special assessment: if the municipal requirement arises outside the budget cycle and the fund is insufficient, a special assessment may be required, according to the voting rules set out in the declaration of co-ownership and the C.C.Q.
- Private portion: for a backwater valve located in a unit, the bill generally goes to the co-owner, with a coordination framework established by the syndicate as needed.
Remember to attach the relevant excerpt from the declaration of co-ownership and a location diagram to any communication. This facilitates buy-in and reduces misunderstandings at the AGM.
- Administration and preservation of the building – section 1039 of the C.C.Q. (LégisQuébec): https://www.legisquebec.gouv.qc.ca/
- Contribution to common expenses – section 1063 of the C.C.Q. (LégisQuébec): https://www.legisquebec.gouv.qc.ca/
- Contingency fund planning – RGCQ: https://rgcq.org/
Need help preparing the call for tenders, communicating with co-owners and maintaining records? See our packages and the About us section to learn about our “Condo management in Montreal” approach.
Maintenance and responsibilities after installation
A backwater valve requires periodic maintenance. Sediment and grease can prevent it from closing tightly.
- Common portion: the board schedules an annual inspection or one according to the contractor’s recommendations. Record the task in the maintenance logbook/EUC and retain the reports.
- Private portion: the co-owner must keep access to the backwater valve clear, have it checked periodically and notify the syndicate of any defect affecting common portions.
- Access and safety: provide a compliant access hatch and clear the area before any technical visit. These rules may be included in the building bylaws.
For more information, consult the RBQ’s technical guides on backflow prevention and make sure the contractor provides installation and compliance certificates.
FAQ – Backwater valves in co-ownership
Q1. Can the City require a backwater valve on every floor?
A. Yes, depending on the configuration of the system. Even if backups mainly affect lower levels, a requirement for overall protection may target the main line and therefore the entire building.
Q2. Who must provide access to the plumbers?
A. The syndicate arranges access to the common portions. For a backwater valve inside a unit, the co-owner must provide access according to the procedures set out in the building bylaws and the notices sent.
Q3. What should be done if a co-owner refuses access or refuses to pay for their private backwater valve?
A. Notify the co-owner in writing, record the matter in the minutes, apply the rules in the declaration of co-ownership and, if necessary, send a formal demand. Costs may be claimed if a failure causes damage, subject to the C.C.Q.
You will find other useful articles on managing work and maintenance on the multiRent blog.
This article provides general information and does not constitute legal advice. Consult a lawyer or notary for advice regarding your situation.
Do you manage a co-ownership in Quebec? Explore our packages or contact us to assess your needs.
